LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. CHECK FOR OPEN IN HARNESS 
    1. Turn ignition switch to OFF position and disconnect HO2S and ECM connectors.
    2. Measure the resistance between terminal 4 of the HO2S harness connector and 19 of the ECM harness connector.

      Specifications: below 1Ω

      Fig 1: Checking For Open In Harness
      G00719761Courtesy of KIA MOTORS AMERICA, INC.

      Is resistance within specification?

      1. Yes:  Go to next step.
      2. No: Repair open circuit in harness.
  2. CHECK HO2S AND ECM CONNECTORS 

    Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .

    Are all connectors good?

    1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
    2. No: Repair or replace it.