LEMON Manuals: Even more car manuals for everyone

Shift Fork And Shift Rod Assembly

  1. Shift to 2nd gear and position shift fork and shift rod assembly as shown in illustration.
    Fig 1: Positioning Shift Fork And Shift Rod Assemblies
    G01078564Courtesy of KIA MOTORS AMERICA, INC.
  2. Insert spring seat and spring into reverse lever shaft, install detent ball, and place a flat gasket scraper against it.
  3. With edge of control end against scraper, push control end in direction of arrow so that detent ball goes into shaft. This will line up rod with shift rod coupling hole in clutch housing.
    Fig 2: Aligning Rod With Shift Rod Coupling Hole
    G01078565Courtesy of KIA MOTORS AMERICA, INC.
  4. Set each clutch hub sleeve to neutral position, and tap shift rod from above so that detent ball goes into center groove (of three grooves in control end).
  5. Pull ball part of control end forward so that detent ball goes into recess in center groove.
    Fig 3: Aligning Detent Ball With Recess In Center Groove
    G01078566Courtesy of KIA MOTORS AMERICA, INC.