LEMON Manuals: Even more car manuals for everyone

ATF Cooler: Installation

  1. Install radiator. See appropriate COOLING SYSTEM article in ENGINES.
  2. Install ATF inlet and outlet pipe. Tighten to specification. See TORQUE SPECIFICATIONS  .
  3. Slide ATF inlet and outlet hose onto ATF cooler pipe until it is fully seated against the ridge. See Figure .
  4. Install hose clamp onto hose at center of mark and at angle shown.
  5. Verify that the hose clamp does not interfere with any other parts. See Fig 1 .
  6. Install RH side gravel shield under engine. Lower vehicle.
  7. Check ATF level. See CHECKING FLUID LEVEL  under LUBRICATION.
Fig 1: Installing Hose Clamp
G00209737Courtesy of KIA MOTORS AMERICA, INC.