DTC P0446: EVAP System Vent Control Circuit Malfunction: Procedure
NOTE:
After any repair has been made, see AFTER-REPAIR PROCEDURE under SELF DIAGNOSTIC SYSTEM.
- Turn ignition off. Disconnect CCV harness connector. Turn ignition on. Measure voltage between ground and CCV harness connector terminal No. 1 (A/T) or CCV harness connector terminal No. 2 (M/T) Pink wire. If battery voltage exists, go to step 3. If battery voltage does not exist, check O2 SENSOR fuse (10-amp) in engine compartment fuse/relay box. If fuse is blown, locate and repair short, then replace fuse. If fuse is okay, go to next step.
- Check for voltage at O2 fuse (input side). If voltage does not exist, replace main relay and retest. If voltage exists, go to next step.
- Turn ignition off. Measure resistance between CCV connector terminals (component side). Resistance should be 23-26 ohms at 68°F (20°C). If resistance is as specified, go to next step. If resistance is not as specified, replace CCV.
- Disconnect ECM harness connector. Measure resistance of White wire between CCV harness connector terminal No. 2 (A/T) and ECM harness connector "A" terminal A35 or terminal No. 1 (M/T) and ECM harness connector "C" terminal C5. See Figure or Figure . If resistance is less than one ohm, go to next step. If resistance is one ohm or more, Check for open in White wire between CCV harness connector and ECM harness connector, repair wire as necessary.
- Check for continuity to ground in White wire between CCV harness connector terminal No. 2 (A/T) and ECM harness connector "A" terminal A35 or terminal No. 1 (M/T) and ECM harness connector "C" terminal C5. If continuity exists, repair short to ground in White wire between CCV and ECM. If continuity does not exist, go to next step.
- Turn ignition on. Measure voltage between ground and ECM harness connector "A" terminal A35 (A/T) or ECM harness connector "C" terminal C5 (M/T). If voltage exists, repair short to power in White wire between CCV and ECM. If voltage does not exist, check harness connectors for loose, damaged or corroded terminals. If problem exists, repair appropriate harness connector. If problem does not exist, temporarily install a known good CCV and check for proper operation. If problem is corrected, replace valve. When repairs are completed, clear DTCs and verify repair.