LEMON Manuals: Even more car manuals for everyone

Removal And Installation: Installation

  1. Install a NEW  O-ring, supplied with the new capless fuel fill receptacle.
    NOTE:

    Make sure that the O-ring is properly positioned in the throat of the fuel fill tube.

  2. Place the new capless fuel fill receptacle in its seat, aligning the groove with the tooth of the fuel fill tube.
    GC0212558Courtesy of CHRYSLER GROUP, LLC
  3. Place the ring (1a) of the installation tool (2000039800) so that the screws (1b) coincide with the four fastening clips of the capless fuel fill receptacle.
    GC0212557Courtesy of CHRYSLER GROUP, LLC
  4. Prepare the installation tool (2000042900) (1a) and (1b) as shown in illustration.
    GC0212556Courtesy of CHRYSLER GROUP, LLC
  5. Position the tools (1a) and (1b) as shown in illustration.
    GC0212203Courtesy of CHRYSLER GROUP, LLC
  6. Check that the jaws have engaged the ring and the collar (a) of the fuel fill tube.
    GC0212555Courtesy of CHRYSLER GROUP, LLC
  7. Tighten the screw (1a) to engage the capless fuel fill receptacle (1b) on the collar of the fuel fill tube.
    GC0163426Courtesy of CHRYSLER GROUP, LLC
  8. Unscrew the screws and remove the driver shown in illustration in the figure (1).
  9. Tighten the screws into the rings to crush the four fasteners.
  10. Remove the tools and verify that the four pegs of the capless fuel fill receptacle are properly installed.
  11. Install the fuel fill door, engaging the retaining clips.
  12. Install the fuel door retaining device and rotate the screw 90°.