LEMON Manuals: Even more car manuals for everyone

Tank, Fuel: Installation: Installation

Fig 1: Removing/Installing Fuel Tank
GC0086097Courtesy of CHRYSLER GROUP, LLC
  1. If fuel pump module is to be installed, install module to tank.
  2. Place fuel tank on a hydraulic jack.
  3. Raise just enough to connect fuel pump module harness connector.
  4. Continue raising tank until snug to body.
  5. Install tank mounting bolts (3) at both sides of tank. Tighten bolts to 61 N.m (45 ft. lbs.).
    Fig 2: Tank Support Bracket, Bolt & Nuts
    GC0086096Courtesy of CHRYSLER GROUP, LLC
  6. Tighten two nuts (3) at tank support bracket (1) to 61 N.m (45 ft. lbs.).
  7. Install bolt (2). Tighten to 61 N.m (45 ft. lbs.).
  8. Install rear propeller shaft. Refer to SHAFT, DRIVE, REAR, INSTALLATION .
    Fig 3: Fuel Fill Hose And Clamp
    GC0138313Courtesy of CHRYSLER GROUP, LLC
  9. Connect vapor lines (1) and (2) at rear of tank.
  10. Connect fuel fill hose and securely tighten clamp (3) at rear of tank.
  11. Remove the hydraulic jack.
    Fig 4: Disconnecting/Connecting Fuel Line Quick Connect Fittings And AT Front Of Fuel Tank
    GC0086094Courtesy of CHRYSLER GROUP, LLC
  12. Connect fuel line quick connect fittings (1) and (2) at front of fuel tank (5).
  13. Lower the vehicle.
  14. Fill tank with fuel and install fuel fill cap.
  15. Connect the negative battery cable.
  16. Start engine and check for fuel leaks.