LEMON Manuals: Even more car manuals for everyone

Installation - Lower

WARNING: This page is about a different variant/trim than selected.

If the following items were removed, install and torque to specifications:

  1. Position a new gasket on cylinder head and install lower manifold.
  2. Install and tighten intake manifold fasteners to 28 N.m (250 in. lbs.) in the sequence shown in (Fig 1 ). Repeat procedure until all bolts are at specified torque.
    Fig 1: Tightening Sequence Lower Intake Manifold
    G03630874Courtesy of DAIMLERCHRYSLER CORP.
  3. Install lower intake manifold support bracket bolts.
    • Bolts to intake 28 N.m (250 in. lbs.)
    • Bolt to engine block 54 N.m (40 ft. lbs.)
  4. Connect the fuel line.
  5. Connect coolant temperature sensor/fuel injector wiring harness electrical connector.
  6. Install the radiator upper and heater supply hoses.
  7. Install the upper intake manifold. Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION  .
  8. Fill the cooling system.