DTC P0645: A/C Clutch Relay Circuit: Testing
- Turn ignition on, engine not running. With the DRBIII®, actuate the A/C Clutch Relay. Is the A/C Clutch Relay clicking? Relay is located in Power Distribution Center (PDC). If yes, go to INTERMITTENT CONDITION under SELF-DIAGNOSTIC SYSTEM. If no, go to next step.
- Turn the ignition off. Remove the A/C Clutch Relay from the PDC. Measure the resistance between terminals No.1 (85) and 2 (86) at the A/C Clutch Relay (component side). Is the resistance between 50.0 and 90.0 ohms? If yes, go to next step. If no, replace the A/C Clutch Relay.
- Turn the ignition off. Remove A/C Clutch Relay from the PDC. Turn ignition on, engine not running. Measure the Fused Ignition Switch Output circuit voltage at the A/C Clutch Relay harness connector in the PDC. Is the voltage above 10.0 volts? If yes, go to next step. If no, repair the open/short to ground in the Fused Ignition Switch Output circuit. Check the related fuse.
- Turn the ignition off. Disconnect the PCM harness connectors. Measure the resistance of the (C13) A/C Clutch Relay Control circuit from the Relay connector to the PCM harness connector. Is the resistance below 5.0 ohms? If yes, go to the next step. If no, repair the open in the (C13) A/C Clutch Relay Control circuit.
- Measure the resistance between ground and the (C13) A/C Clutch Relay Control circuit at the PCM harness connector. Is the resistance below 100 ohms? If yes, repair the short to ground in the (C13) A/C Clutch Relay Control circuit. If no, go to the next step.
- Using the wiring diagram as a guide, inspect the wire harness and connectors. Pay particular attention to all power and ground circuits. If there are no possible causes remaining, replace PCM. Program the new PCM. See PROGRAMMING .
NOTE:
Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.