LEMON Manuals: Even more car manuals for everyone

PDC Relay Cassette: Removal

The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC mini fuse wedge, the PDC relay cassettes and the PDC B(+) terminal stud module are available for service replacement. The PDC cover can be simply unlatched and removed from the PDC housing without the PDC being removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its mounting and disassembled. Refer to FUSES & CIRCUIT BREAKERS .

  1. Remove the relay wedge from the PDC relay cassette to be removed.
    NOTE: It may be necessary to remove relay cassettes that are not being serviced from the PDC housing in order to obtain sufficient clearance to access the faulty relay cassette. The same service procedure is repeated as necessary to remove each of the interfering relay wedges and relay cassettes from the PDC housing.
  2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the relay cassette in the PDC (Fig 1 ).
    Fig 1: Removing PDC Relay Cassette Latches
    G02706855Courtesy of DAIMLERCHRYSLER CORP.
  3. Gently and evenly press the relay cassette down through the PDC housing.
  4. From the bottom of the PDC housing, remove the relay cassette from the PDC (Fig 2 ).
CAUTION: Do not remove the wiring and terminals from the terminal cavities of the faulty PDC relay cassette at this time. Refer to ASSEMBLY  procedure for the proper procedures for transferring the wiring and terminals to the replacement PDC relay cassette.
Fig 2: Removing Relay Cassette From PDC
G02706856Courtesy of DAIMLERCHRYSLER CORP.