LEMON Manuals: Even more car manuals for everyone

DTC P1687: No Cluster Bus Message: Testing

  1. Turn ignition on, with engine off. Using scan tool, check for DTCs. If DTC P1687 is present and set counter on scan tool display equals zero, go to next step. If DTC P1687 is not present, or set counter on scan tool display does not equal zero, go to step 3 .
  2. Using scan tool, select BODY system, then ELECTRO/MECH CLUSTER. If scan tool does not communicate with instrument cluster, go to BUS (+) & BUS (-) OPEN, BUS (+) OPEN OR BUS (-) OPEN under SYSTEM TESTS in BODY CONTROL MODULES - WRANGLER article in ACCESSORIES & EQUIPMENT. If scan tool communicates with instrument cluster, go to NO RESPONSE FROM POWERTRAIN CONTROL MODULE under SYSTEM TESTS in BODY CONTROL MODULES - WRANGLER article in ACCESSORIES & EQUIPMENT.
  3. Turn ignition off. It is assumed that there is an intermittent problem with wiring harness and/or connectors. Visually inspect all related connectors and wiring harness for any possible problems. Repair wiring or connectors as necessary. Also, check for any related technical service bulletins. If no problems are found, test is complete.