LEMON Manuals: Even more car manuals for everyone

Test 12F - Bus Short To Battery

WARNING: This page is about a different car, the 1996 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using external ohmmeter, measure resistance between Body Control Module (BCM) Black connector, terminals No. 12 (Brown/Tan wire) and No. 19 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Brown/Tan wire and Violet/Brown. If resistance is 5 ohms or greater, go to next step.
  2. Measure resistance between Body Control Module (BCM) Black connector, terminals No. 12 (Brown/Tan wire) and No. 20 (White/Black wire). If resistance is less than 5 ohms, repair short between Brown/Tan wire and White/Black. If resistance is 5 ohms or greater, go to next step.
  3. Using scan tool in ohmmeter mode, measure resistance on BCM Black connector, terminal No. 16 (Black/Orange wire). If resistance is 5 ohms or greater, repair open Black/Orange wire. If resistance is less than 5 ohms, go to next step.
  4. Using scan tool in ohmmeter mode, measure resistance on BCM Black connector, terminal No. 2 (Light Green/White wire). If resistance is 5 ohms or greater, repair open Light Green/White wire. If resistance is less than 5 ohms, replace BCM.
NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAM  . After each repair, perform VERIFICATION TEST VER-1.
CAUTION: Always turn ignition off prior to disconnecting any module connector.