Power Lumbar Adjuster/Motor Test
NOTE:
The following test is for models without power seat memory system option. For testing of power seats with memory system, see BODY CONTROL COMPUTER
article.
- Operate power lumbar switch in both directions. If power lumbar operates in one direction only, move adjuster a short distance in opposite direction and test again to ensure adjuster is not at its travel limit. If power lumbar still operates in one direction only, see POWER LUMBAR SWITCH TEST . If power lumbar is inoperative in both directions, go to next step.
- Check circuit breaker. See CIRCUIT BREAKER TEST . Replace circuit breaker as necessary. Recheck system operation. If circuit breaker is okay, remove power lumbar switch. See POWER LUMBAR SWITCH R & I . Using a voltmeter, measure voltage between ground and terminal No. 3 (Red wire) at power lumbar wiring harness connector. If battery voltage is present, go to next step. If battery voltage is not present, repair open in Red wire between circuit breaker No. 3 and power lumbar switch.
- Using an ohmmeter, check for continuity between ground and terminals No. 2 (Black wire) and No. 4 (Black wire) at power lumbar switch wiring harness connector. If continuity exists in both wires, go to next step. If continuity does not exist in one or both wires, repair open in appropriate Black wire between power lumbar switch and ground.
- Test power lumbar switch. See POWER LUMBAR SWITCH TEST . Replace switch as necessary and recheck system operation. If switch is okay, replace faulty power lumbar adjuster/motor assembly and recheck system operation.