LEMON Manuals: Even more car manuals for everyone

Test 3A - No Response From Air Temperature Control (ATC)

  1. Turn ignition off. Disconnect ATC head harness connector. Connect jumper wire between ground and terminal No. C10 (Violet/Brown wire) on ATC head harness connector. Turn ignition on. Using scan tool, perform CCD bus test. If scan tool displays short to ground, go to next step. If scan tool does not display short to ground, repair open Violet/Brown wire.
  2. Remove jumper wire. Connect jumper wire between ground and terminal No. C11 (White/Black wire) on ATC head harness connector. Turn ignition on. Using scan tool, perform CCD bus test. If scan tool displays short to ground, go to next step. If scan tool does not display short to ground, repair open White/Black wire.
  3. Using external voltmeter, measure voltage between ground and terminal No. C12 (Dark Green/Pink wire) on ATC head harness connector. If voltage is 10 volts or less, repair open Dark Green/Pink wire. If voltage is greater than 10 volts, go to next step.
  4. Measure voltage between ground and terminal No. C13 (White/Red wire) on ATC head harness connector. If voltage is 10 volts or less, repair open White/Red wire. If voltage is greater than 10 volts, go to next step.
  5. Using external ohmmeter, measure resistance between ground and terminal No. D7 (Pink wire) on ATC head harness connector. If resistance is less than 5 ohms, replace ATC head module. If resistance is 5 ohms or greater, repair open Pink wire.
NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition off prior to disconnecting any module connector.
NOTE: Ignition off during bus test is most common cause for this trouble code.