Chime Test 3A - Chime Sounds With Driver's Seat Belt Fastened
NOTE:
Perform CHIME TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. After each repair, perform TEST VER-1A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Turn ignition off. Fasten left front seat belt. Turn ignition on, engine off. If chime does not sound, chime system is currently operating properly. If chime sounds, go to next step.
- Using scan tool, select CHIME MONITORS. Read seat belt switch status. If scan tool does not display SEAT BELT SWITCH CLOSED, replace Body Control Module (BCM). BCM is located under left side of dash. See Fig 1 . If scan tool displays SEAT BELT SWITCH CLOSED, disconnect left seat belt switch. Go to next step.
- Using scan tool, read seat belt switch status. If scan tool does not display SEAT BELT SWITCH CLOSED, replace seat belt switch. If scan tool displays SEAT BELT SWITCH CLOSED, go to next step.
- Disconnect BCM Black 14-pin connector. Using scan tool, read seat belt switch status. If scan tool displays SEAT BELT SWITCH CLOSED, replace BCM. If scan tool does not display SEAT BELT SWITCH CLOSED, repair short in Light Green/Red wire between terminal No. 14 on BCM Black 14-pin connector and terminal No. 1 on seat belt switch connector.