Test TC-18A - EVAP Purge Solenoid Circuit
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
- Using scan tool read and record DTCs. Erase DTCs and monitor PURGE SOLENOID STATE. Start engine and allow it to reach normal operating temperature. Disconnect EVAP purge solenoid vacuum hose (between EVAP purge solenoid and EVAP canister). If vacuum does not exist when scan tool displays DUTY CYCLE MORE THAN 0 PERCENT, go to step 5). If vacuum exists in hose when scan tool displays DUTY CYCLE MORE THAN 0 PERCENT, go to next step.
- Condition required to set DTC is not present at this time. EVAP PURGE SOLENOID CIRCUIT DTC sets if actual state of EVAP purge solenoid operation does not match intended state. Possible causes are: open or shorted wiring to EVAP purge solenoid, defective EVAP purge solenoid or PCM. Go to next step.
- Check for defective wiring and connections at EVAP purge solenoid, PCM and fused voltage supply wiring to EVAP purge solenoid. Repair wiring and connectors as necessary and perform TEST VER-2A. If wiring and connectors are okay, go to next step.
- Using scan tool, read DTCs. Ensure actuator test is still running. Wiggle wiring harness from EVAP purge solenoid to PCM. If EVAP PURGE SOLENOID CIRCUIT DTC resets, repair wiring harness as necessary and perform TEST VER-2A. If DTC does not reset, see INACTIVE DTC CONDITION. Test is complete. Perform TEST VER-2A.
- Turn ignition off. Disconnect EVAP purge solenoid connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
- Turn ignition on. Using an external voltmeter, check voltage on EVAP purge solenoid connector, fused ignition switch output circuit (Red/Light Green wire). If voltage is 10 volts or less, repair open fused ignition switch output circuit and perform TEST VER-2A. If voltage is more than 10 volts, go to next step.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connectors. Inspect connectors and terminals for damage. Repair connectors and terminals as necessary and perform TEST VER-2A. If connectors and terminals are okay, go to next step.
- Using an external ohmmeter, check resistance of EVAP purge solenoid control circuit (Pink/Black wire) between EVAP purge solenoid connector and PCM Gray connector. If resistance is 5 ohms or more, repair open EVAP purge solenoid control circuit and perform TEST VER-2A. If resistance is less than 5 ohms, go to next step.
- Check resistance between ground and PCM Gray connector, EVAP purge solenoid control circuit (Pink/Black wire). If resistance is less than 5 ohms, repair short to ground in EVAP purge solenoid control circuit and perform TEST VER-2A. If resistance is 5 ohms or more, go to next step.
- Reconnect EVAP purge solenoid connector. Turn ignition on. Using an external voltmeter, check voltage on PCM Gray connector, EVAP purge control solenoid circuit (Pink/Black wire). If voltage is 10 volts or less, replace EVAP purge solenoid and perform TEST VER-2A. If voltage is more than 10 volts, replace PCM and perform TEST VER-2A.