LEMON Manuals: Even more car manuals for everyone

Test TC-171D - Governor Pressure Solenoid Circuit

NOTE: Perform TEST TC-171A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
  1. Repair governor pressure solenoid control circuit for short to voltage. Perform TEST VER-2A. Connect all disconnected connectors and go to next step.
  2. Using scan tool, perform GOV and 3-4 shift test. Select 1st gear and read governor pressure voltage. If voltage is one volt or more, replace PCM and perform TEST VER-2A. If voltage is less than one volt, test is complete.
NOTE: A break in test sequence occurs at this point. Sequence skips from TEST TC-171D to TEST TC-173A. No tests have been omitted.