Test TC-171C - Governor Pressure Solenoid/Trans Relay CKTS
NOTE:
Perform TEST TC-171A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
- Turn ignition off. Disconnect transmission solenoid connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
- Using an external ohmmeter, check and record resistance between transmission solenoid connector, governor pressure solenoid control circuit (Pink wire) and all other circuits in solenoid connector. If resistance is less than 2.5 ohms between any 2 circuits, repair governor pressure solenoid control circuit for a short to other circuit(s), perform TEST VER-2A and go to step 4). If resistance is 2.5 ohms or more between all circuits, go to next step.
- Drain and remove transmission pan. Disconnect governor pressure solenoid connector. Check resistance across governor pressure solenoid. If resistance is less than 2.5 ohms, replace governor pressure solenoid, perform TEST VER-2A and go to next step. If resistance is 2.5 ohms or more, replace transmission solenoid and harness assembly, perform TEST VER-2A and go to next step.
- Using scan tool, perform GOV and 3-4 shift test. Select 1st gear and read governor pressure voltage. If voltage is one volt or more, replace PCM and perform TEST VER-2A. If voltage is less than one volt, test is complete.