LEMON Manuals: Even more car manuals for everyone

Test TC-171B - Governor Pressure Solenoid/Trans Relay CKTS

NOTE: Perform TEST TC-171A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
  1. Turn ignition off. Remove transmission control relay. Inspect transmission control relay connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  2. Turn ignition off. Using an external ohmmeter, check resistance between ground and transmission control relay connector, transmission control relay output circuit (Light Blue wire). If resistance is less than 5 ohms, repair short to ground in transmission control relay output circuit and perform TEST VER-2A. If resistance is 5 ohms or more, go to next step.
  3. Check resistance of transmission control relay output circuit (Light Blue wire) between transmission solenoid connector and transmission relay connector. If resistance is more than 5 ohms, repair open transmission control relay circuit and perform TEST VER-2A. If resistance is 5 ohms or less, go to next step.
  4. Turn ignition on. Using scan tool, check voltage on transmission control relay connector, fused B+ circuit (Red/White wire). If voltage is 10 volts or less, repair open fused B+ circuit and perform TEST VER-2A. If voltage is more than 10 volts, replace transmission control relay and perform TEST VER-2A.