LEMON Manuals: Even more car manuals for everyone

Test TC-157B - Intermittent Loss Of CMP Or CKP

NOTE: Perform TEST TC-157A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) Black connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  2. Disconnect CMP sensor connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  3. Disconnect CKP sensor connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  4. Reconnect PCM, CMP and CKP connectors. Start engine and allow it to idle. Go to next step.
  5. Using scan tool, read engine speed (RPM) while wiggling CMP and CKP wiring harness. If RPM changes while wiggling wiring harness, repair wiring harness as necessary and perform TEST VER-2A. If RPM does not change, go to next step.
  6. Inspect all related wiring and connectors. Repair wiring and connectors as necessary and perform TEST VER-2A. If connectors and terminals are okay, go to next step.
  7. Condition required to set DTC is not present at this time. INTERMITTENT LOSS OF CMP or CKP DTC sets when PCM senses a cam signal level that disagrees with actual cam signal level. Possible causes are: open or shorted 5-volt supply circuit, open sensor ground, open or shorted signal circuit, excessive clearance between crankshaft sensor and crankshaft pulse ring, excessive clearance between crankshaft sensor and target magnet, damaged target magnet, failed sensor or failed PCM. Go to next step.
  8. See INACTIVE DTC CONDITIONS. Test is complete. Perform TEST VER-2A.