Test TC-157A - Intermittent Loss Of CMP Or CKP
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
- INTERMITTENT LOSS OF CMP OR CKP DTC sets when expected Camshaft Position (CMP) sensor signal level disagrees with actual CMP signal level. Possible causes are: open or shorted 5-volt supply circuit, open sensor ground, open or shorted signal circuit, excessive clearance between Crankshaft Position (CKP) sensor and crankshaft pulse ring, excessive clearance between CKP sensor and target magnet, damaged target magnet, defective sensor or defective PCM. Go to next step.
- Use scan tool in set sync mode to check distributor position. Set distributor to specification using procedure in TEST NS-8A if necessary and perform TEST VER-2A. If distributor is set to specification, go to next step.NOTE: Refer to manufacturer's operation manual for instructions in use of oscilloscope and procedure for pattern analysis.
- Turn ignition off. Disconnect CMP sensor connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
- Disconnect Powertrain Control Module (PCM) Black connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, perform TEST TC-157C.
- Backprobe oscilloscope's voltage lead at PCM Black connector, CMP signal circuit (Tan/Yellow wire). Wiggle wiring harness from PCM to CMP sensor while observing oscilloscope pattern. If sensor signal does not remain consistent while wiggling wiring harness, repair wiring harness as necessary where wiggling caused inconsistent pattern and perform TEST VER-2A. If sensor signal is consistent, go to next step.
- Turn ignition off. With CKP sensor connected, backprobe oscillo-scope's voltage lead at CKP sensor connector, CKP sensor circuit (Gray/Black wire). Start engine. If sensor signal pattern is consistent, go to step 10). If sensor signal pattern is not consistent, go to next step.
- Turn ignition off. Disconnect CKP sensor connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
- Disconnect Powertrain Control Module (PCM) Black connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, perform TEST TC-157D.
- Using oscilloscope's voltage lead, backprobe at PCM Black connector, CKP signal circuit (Gray/Black wire). Wiggle wiring harness from PCM to CKP sensor while observing oscilloscope pattern. If sensor signal does not remain consistent while wiggling wiring harness, repair wiring harness as necessary where wiggling caused inconsistent pattern and perform TEST VER-2A. If sensor signal is consistent, go to next step.
- Condition required to set DTC is not present at this time. See INACTIVE DTC CONDITION. Test is complete. Perform TEST VER-2A.