LEMON Manuals: Even more car manuals for everyone

Test NTC-8A - Checking Oxygen Sensor Heater

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
CAUTION: Allow Heated Oxygen Sensor (HO2S) to cool to room temperature before checking resistance.
NOTE: 1/1 HO2S is located in upstream position. On models with 2 upstream HO2S, 1/1 HO2S is located in left upstream position. 1/2 HO2S is located in downstream position. On models equipped with 4 HO2S, 1/2 HO2S is located in left downstream position. 2/1 HO2S is located in right upstream position on models with 2 upstream HO2S.
  1. Turn ignition on. Using scan tool, actuate HO2S heater test. Wait 2 minutes for HO2S voltages to stabilize. Go to next step.
  2. Using scan tool, read HO2S signal voltage. If voltage is one volt or more on all HO2S, stop actuation test. Test passed. If voltage is more than one volt on any HO2S, go to next step.
  3. Turn ignition off. Disconnect suspected HO2S connector. inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  4. Ensure scan tool is still actuating heater test. Using scan tool in voltmeter mode, check voltage on HO2S connector, ASD relay output circuit (Dark Green/Black wire). If voltage is 10 volts or less, repair open ASD relay output circuit and perform TEST VER-2A. If voltage is more than 10 volts, go to next step.
  5. Stop actuation test. Using an external ohmmeter, check resistance between ground and HO2S connector, heater ground (Black wire). If resistance is 5 ohms or more, repair open heater ground circuit and perform TEST VER-2A. If resistance is less than 5 ohms, replace HO2S and perform TEST VER-2A.