Test NTC-21B - Checking Water-In-Fuel - Lamp & Sensor
NOTE:
Perform TEST NTC-21A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
Turn ignition off. Disconnect jumper wire. Using scan tool in ohmmeter mode, check resistance of WIF sensor connector, ground circuit (Black/Light Blue wire). If resistance is more than 5 ohms, repair open ground circuit and perform TEST VER-2A. If resistance is 5 ohms or less, replace WIF sensor and perform TEST VER-2A.