LEMON Manuals: Even more car manuals for everyone

Test NTC-19A - Checking Fuel Heater

NOTE: This test applies to vehicles equipped with diesel engines only. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
NOTE: To hear click in next step, it may be necessary to remove and install relay several times.
  1. Turn ignition on. While listening for relay to click, remove fuel heater relay. If relay clicks, go to step 5). If relay does not click, go to next step.
  2. Inspect fuel heater relay connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-1A. If connector and terminals are okay, go to next step.
  3. Turn ignition on. Using scan tool in voltmeter mode, check voltage on fuel heater relay connector, fused ignition switch output circuit (Light Green/Black wire). If voltage is 10 volts or less, repair open fused ignition switch output circuit and perform TEST VER-1A. If voltage is more than 10 volts, go to next step.
  4. Turn ignition off. Using scan tool in ohmmeter mode, check resistance of fuel heater relay connector, ground circuit (Black/Tan wire). If resistance is 5 ohms or more, repair open ground circuit and perform TEST VER-1A. If resistance is less than 5 ohms, replace fuel heater relay an perform TEST VER-1A.
  5. Turn ignition off. Disconnect fuel heater connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-1A. If connector and terminals are okay, go to next step.
  6. Using scan tool in ohmmeter mode, check resistance of fuel heater connector, ground circuit (Black/Tan wire). If resistance is 5 ohms or more, repair open ground circuit and perform TEST VER-1A. If resistance is less than 5 ohms, go to next step.
  7. Turn ignition on. Using scan tool in voltmeter mode, check voltage on fuel heater relay connector, fused B+ circuit (Red/Tan wire). If voltage is less than 10 volts, repair open fused B+ circuit and perform TEST VER-1A. If voltage is less than 10 volts, go to next step.
  8. Turn ignition off. Using an external ohmmeter, check resistance of fuel heater relay output circuit (Red/Black wire) between fuel heater relay connector and fuel heater connector. If resistance is more than 5 ohms, repair open fuel heater relay output circuit and perform TEST VER-1A. If resistance is 5 ohms or less, go to next step.
  9. Disconnect fuel heater element connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-1A. If connector and terminals are okay, go to next step.
    NOTE: Ensure fuel heater element temperature is less than 40°F (4.4°C).
  10. Reconnect fuel heater element connector. Using an external ohmmeter, check resistance across fuel heater connector terminals (component side). If resistance is 5 ohms or less, fuel heater is operating normally. Test passed. If resistance is more than 5 ohms, replace fuel heater and perform TEST VER-1A.