LEMON Manuals: Even more car manuals for everyone

Test NTC-11A - Checking Pcm Power & Ground Circuits

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) Black connector. Inspect connector and terminals for damage. Repair connector and terminals as necessary and perform TEST VER-2A. If connector and terminals are okay, go to next step.
  2. Using scan tool in ohmmeter mode, check resistance of PCM Black connector terminal No. 31, ground circuit (Black/Tan wire). If resistance is 5 ohms or more, repair open ground circuit and perform TESTVER-2A. If resistance is less than 5 ohms, go to next step.
  3. Using scan tool in ohmmeter mode, check resistance of PCM Black connector terminal No. 32, ground circuit (Black/Tan wire). If resistance is 5 ohms or more, repair open ground circuit and perform TESTVER-2A. If resistance is less than 5 ohms, go to next step.
  4. Using scan tool in voltmeter mode, check voltage on of PCM Black connector, fused B+ circuit (Red/White wire). If voltage is 10 volts or less, repair open B+ circuit and perform TEST VER-2A. If voltage is more than 10 volts, go to next step.
  5. Turn ignition on. Check voltage on PCM Black connector, ignition switch output circuit. See IGNITION SWITCH OUTPUT CIRCUIT IDENTIFICATION table. If voltage is 10 volts or less, repair open ignition switch output circuit and perform TEST VER-2A. If voltage is more than 10 volts, go to next step.
    IGNITION SWITCH OUTPUT CIRCUIT IDENTIFICATION

    Application Wire Color
    TJ Body Red/Light Green
  6. Turn ignition off. Reconnect PCM connector. PCM ground and power circuits are operating properly. Test passed.