Test 21A - "G" Switch Not Processable
NOTE:
Perform TEST 1A before proceeding. For connector terminal and circuit identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAM . Perform TEST VER-1A after each repair. "G" switch may also be called acceleration switch.
- Ensure "G" switch is properly installed and go to next step. If not properly installed, repair as necessary.
- Turn ignition off. Disconnect Controller Anti-Lock Brake (CAB) connectors. Disconnect "G" switch 3-pin connector. Check all connectors for corroded, damaged or backed-out terminal pins. Repair as necessary. If connectors are okay, go to next step.
- Turn ignition on. Using scan tool in voltmeter mode, check voltage on "G" switch connector terminal No. 2. If voltage is present, repair "G" switch No. 1 sense circuit for short to B+. If no voltage is present, go to next step.
- Check voltage on "G" switch connector terminal No. 3. If voltage is present, repair "G" switch No. 2 sense circuit for short to B+. If no voltage is present, go to next step.
- Check voltage on "G" switch connector terminal No. 1. If voltage is present, repair "G" switch test signal circuit for short to B+. If no voltage is present, go to next step.
- Turn ignition off. Using scan tool in ohmmeter mode, check resistance on "G" switch connector terminal No. 1. If resistance is less than 5 ohms, repair test signal circuit for a short to ground. If resistance is not as specified, go to next step.
- Check resistance of "G" switch connector terminal No. 2. If resistance is less than 5 ohms, repair "G" switch No. 1 sense circuit for a short to ground. If resistance is not a specified, go to next step.
- Check resistance of "G" switch connector terminal No. 3. If resistance is less than 5 ohms, repair "G" switch No. 2 sense circuit for a short to ground. If resistance is not as specified, go to next step.
- Reconnect CAB connector. Turn ignition on. Connect a fused jumper wire between "G" switch connector terminals No. 1 and 2. Using scan tool, read "G" switch status. If scan tool displays "G" SWITCH # 1 = CLOSED, go to next step. If scan tool display is not as specified, go to step 12).
- Move jumper wire to "G" switch connector terminals No. 1 and 3. Using scan tool, read "G" switch status. If scan tool displays "G" SWITCH # 2 = CLOSED, replace "G" switch assembly. If scan tool display is not as specified, go to next step.
- Turn ignition off. Reconnect "G" switch connector. Disconnect CAB connectors. Using an external ohmmeter, check resistance between CAB connector "A", terminal A2 and A7. If resistance is less than 5 ohms, replace CAB. If resistance is not as specified, repair open in "G" switch No. 2 sense circuit.
- Turn ignition off. Disconnect CAB connectors. Check connectors for corroded, damaged or backed-out terminal pins. Repair as necessary. If connectors are okay, go to next step.
- Connect a fused jumper wire between CAB connector "A", terminal A2 and CAB connector "B", terminal B13. Check resistance of "G" switch connector terminal No. 1. If resistance is less than 10 ohms, go to next step. If resistance is not as specified, repair open in "G" switch test signal circuit.
- Remove jumper wire and reconnect "G" switch connector. Check resistance between CAB connector "A", terminals A2 and A6. If resistance is less than 5 ohms, replace CAB. If resistance is not as specified, repair open in "G" switch No. 1 sense circuit.