Pre-Diagnostic Inspection
- Check master cylinder reservoir for correct fluid level. Inspect ABS Hydraulic Control Unit (HCU) for leakage and wiring damage. Check each caliper piston for activation and release. Check all brakes to verify no drag exists.
- Check Wheel Speed Sensors (WSS) for correct mounting and alignment. Inspect wire harness for correct routing. Ensure connectors are not damaged and have good contact.
- Verify all wheel bearings are not worn or causing wheel wobble. Ensure all tires are in good condition and are properly inflated. Proper ABS operation is dependent on accurate signals from each WSS. Ensure all wheels and tires are of same size, type and manufacturer. After performing pre-diagnostic inspection, perform TEST 1A under SELF-DIAGNOSTIC TESTS using scan tool.