LEMON Manuals: Even more car manuals for everyone

Diagnostic Test Procedure

  1. Turn ignition off. Disconnect negative battery cable. Disconnect ECM connector EM80. Disconnect CCV connector. Measure resistance between ECM connector EM80 terminal No. 2 and CCV connector terminal No. 1. Is resistance greater than 5 ohms? If yes, repair high resistance between ECM connector EM80 terminal No. 2 and CCV connector terminal No. 1. Clear DTC and carry out a full EVAP system monitor drive cycle. See DRIVE CYCLES . If no, go to next step.
  2. Reconnect negative battery cable. Measure resistance between CCV connector terminal No. 1 and ground. Is resistance less than 10,000 ohms? If yes, repair short between CCV connector terminal No. 1 and ground. Clear DTC and carry out a full EVAP system monitor drive cycle. See DRIVE CYCLES . If no, install a new CCV. Clear DTC and carry out a full EVAP system monitor drive cycle. See DRIVE CYCLES . Recheck DTC(s). If DTC resets, possible ECM failure.