LEMON Manuals: Even more car manuals for everyone

Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

  1. 2 -  A "NO RPL" condition accompanied by a no-start condition suggests a faulty ECM ignition feed or battery circuit.
  2. 9 -  Using a test light connected to battery voltage, probe each of the Multiplex Control Unit (MCU) ground terminals to verify that a good ground is present.
  3. 12 -  In this step temporarily substitute a known good relay for the ECM relay. Horn relay also located in fuse/relay box is like ECM relay. Verify horn relay by pressing horn button to ensure horn is operational. If horn relay tests good, install relay to ECM relay position for test purposes.
  4. 17 -  Vehicle is equipped with a Electrically Erasable Programmable Read Only Memory (EEPROM). When ECM is replaced, the new ECM must be programmed. See EEPROM PROGRAMMING PROCEDURE  under POWERTRAIN CONTROL MODULE.