Code Enable Criteria
Following conditions must be met for DTC diagnostic test to run:
- No TP sensor, VSS, ECT sensor, EGR, MAF sensor, MAP sensor, IAT sensor, HO2S, low system voltage, fuel system, EVAP canister purge, fuel injector control or ignition control DTCs are stored.
- EVAP canister purge duty cycle is 10 percent or more.
- Engine running time is more than 125 seconds.
- Engine coolant temperature is 122°F (50°C) or more.
- Idle control condition is NORMAL.
- Ignition voltage is 9.5-16.7 volts.
- Barometric pressure is 74.5 kPa or more.
- Above conditions are met for 5 seconds or more.
- Engine idle speed is more than 100 RPM and MAP is less than 60 kPa for 10 seconds.