Diagnostic Procedure
NOTE:
For better performance and results of this diagnostic procedure, usage of appropriate wiring diagram is recommended. See ENGINE PERFORMANCE
in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
NOTE:
Perform all voltage and resistance tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use an ohmmeter to isolate wiring harness shorts or opens.
- Perform ON-BOARD DIAGNOSTIC II SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. After performing OBD-II system check, go to next step.
- If any ECT sensor DTCs are set, repair those DTCs first. For diagnostic procedure, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are set, go to next step.
- Allow engine to cool. Ensure coolant level is full. If coolant level is okay, go to next step. If coolant level is low, go to step 9 .
- Start engine and let idle. Using scan tool, observe ENG COOL TEMP parameter. If display does not increases to 70°F (21°C) or more within 2 minutes, go to next step. If display increases to 70°F (21°C) or more within 2 minutes, check for an intermittent problem. See DIAGNOSTIC AIDS .
- Check thermostat for proper operation. If thermostat is okay, go to next step. If thermostat does not operate properly, go to step 9 .
- Using a thermometer, check temperature of coolant in radiator. Compare reading with display on scan tool. If temperature readings are not close, go to next step. If temperature readings are close, go to step 9 .
- Turn ignition off. Disconnect ECM 80-pin harness connector E-21. ECM is located at left rear of engine compartment, near air filter housing. See Figure . Using DVOM, measure ECT sensor resistance at ECM harness connector E-21 terminal No. 74 (Blue/Red wire) and No. 53 (Yellow/Black wire). See Figure . Compare resistance reading with coolant temperature reading. See ENGINE COOLANT TEMPERATURE SENSOR RESISTANCE table. If temperature readings are not close to being equal, go to next step. If temperature readings are close to being equal, go to step 12 .
- Check for high resistance in ECT sensor signal circuit or sensor ground circuit between ECM and ECT sensor. Check for poor connections at ECM and ECT sensor harness connections. If problem with wiring is found, go to step 10 . If no problem with wiring is found, go to step 11 .
- Check for cooling system faults (radiator, thermostat, water pump, etc.) or coolant leaks. If problem is found, repair as necessary. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Repair or replace faulty wiring or terminals as necessary. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Replace ECT sensor. See ENGINE COOLANT TEMPERATURE SENSOR under SENSORS & SWITCHES in REMOVAL & INSTALLATION article. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Replace and reprogram ECM. See POWERTRAIN CONTROL MODULE REPLACEMENT under POWERTRAIN CONTROL MODULE. Use scan tool to clear DTC and verify repair.