Diagnostic Procedure
NOTE:
For better performance and results of this diagnostic procedure, usage of appropriate wiring diagram is recommended. See ENGINE PERFORMANCE
in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
NOTE:
Perform all voltage and resistance tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use an ohmmeter to isolate wiring harness shorts or opens.
- Perform ON-BOARD DIAGNOSTIC II SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. After performing OBD-II system check, go to next step.
- Turn ignition off. Disconnect Mass Airflow (MAF) sensor 3-pin harness connector. MAF sensor is located in air intake pipe, at air cleaner housing. See Figure . Connect test light between MAF sensor harness connector terminal No. 2 (Black wire) and No. 3 (Black/Yellow wire). See Fig 1 . Turn ignition on. If test light does not illuminate, leave ignition on and go to next step. If test light illuminates, go to step 6 .
- Using DVOM, measure voltage between MAF sensor harness connector terminal No. 2 (Black wire) and No. 3 (Black/Yellow wire). See Fig 1 . Voltage should be 11.5-12.5 volts. If voltage is not as specified, go to next step. If voltage is as specified, go to step 5 .
- Turn ignition off. Check for open or short to ground in Black/Yellow wire (battery voltage) between MAF sensor and CB-12 ENGINE (15-amp) fuse. If problem is found, repair circuit as necessary. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Check for open or short to ground in Black wire between ground point E-30 and MAF sensor terminal No. 2. Ground point E-30 is located on right side of intake plenum. See Fig 2 . If problem is found, repair circuit as necessary. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition off. Check for open or short to ground or short to voltage in Black/Blue wire between ECM and MAF sensor. If no problem is found, go to next step. If problem is found, repair as necessary. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Connect MAF sensor harness connector. Connect TECH 2 or equivalent scan tool to DLC. DLC is located under left side of instrument panel. See Figure . Place transmission in Park or Neutral and apply parking brake. Start and idle engine. Using scan tool, observe MAF sensor parameter. If parameter displays 4-7 grams/sec., leave engine running and go to next step. If parameter does not display 4-7 grams/sec., go to step 9 .
- Briefly press throttle wide open. On scan tool, observe MAF sensor parameter. MAF sensor parameter should display 25-40 grams/sec. If parameter displays as specified, go to step 10 . If parameter does not display as specified, go to next step.
- Replace MAF sensor. See MASS AIR FLOW SENSOR under SENSORS & SWITCHES in REMOVAL & INSTALLATION article. After repair is complete, see VERIFYING VEHICLE REPAIR under SELF-DIAGNOSTIC SYSTEM.
- Replace and reprogram ECM. See POWERTRAIN CONTROL MODULE REPLACEMENT under POWERTRAIN CONTROL MODULE. Use scan tool to clear DTC and verify repair.