Spark Knock/Detonation: Ascender
- Perform On-Board Diagnostic II System Check.
- Perform Electronic Throttle Control (ETC) System Check.
- Check for engine running hot because of low coolant or other cooling system faults.
- Inspect for a correct coolant mixture.
- Inspect for the proper tension on the drive belts.
- Inspect for restricted air flow through the radiator, or restricted coolant flow.
- Inspect for faulty thermostat.
- Inspect for an Engine Coolant Temperature (ECT) sensor that has shift in value.
- Drive the vehicle at the speed of the complaint. Monitoring the fuel trim will help identify the problem.
- If the system is lean, the long term fuel trim will be more than 150.
- If the fuel trim readings are normal and there are no engine mechanical concerns, then fill the fuel tank with a known good fuel and re-evaluate the vehicle performance.
- Test the fuel pressure. See FUEL SYSTEM DIAGNOSIS in BASIC DIAGNOSTIC PROCEDURES article.
- Inspect for a poor fuel quality and a proper octane rating.
- Inspect the spark plugs for their proper heat range and gap.
- Inspect the Knock Sensor (KS) system operation.
- Inspect the ignition timing.
- Inspect for carbon build up. Remove the carbon with a top engine cleaner.
- Test the combustion chamber pressure by performing a compression test. See COMPRESSION in BASIC DIAGNOSTIC PROCEDURES article.
- Inspect the Torque Converter Clutch (TCC) operation. See appropriate AUTOMATIC TRANSMISSIONS article.
- Search for Service Bulletins for calibration updates.