LEMON Manuals: Even more car manuals for everyone

Injection Pump & Timing Belt: Installation

  1. Install injection pump, aligning marks on flange and front bracket. Install injection pump pulley, using holding bolt to keep pulley from turning. Set No. 1 cylinder at TDC of compression stroke.
  2. Align pulleys so marks are together. See Fig 1 . Install timing belt on crankshaft pulley, camshaft pulley and injection pump pulley in order. Position belt so slack is near idler pulley.
    Fig 1: Timing Belt Pulley Alignment
    G34970Courtesy of ISUZU MOTOR CO.
    Fig 2: Exploded View of Injection Pump Assembly
    G36054Courtesy of ISUZU MOTOR CO.
  3. Install idler pulley. Ensure base is aligned against 2 pins on timing pulley housing. Hand-tighten pulley nut. Install spring and tighten nut to 22-36 ft. lbs. (30-49 N.m). Turn crankshaft 2 revolutions, then 90 degrees more beyond TDC.
    CAUTION: Always turn engine in firing rotation. Do not rotate in reverse direction.
  4. Loosen tension pulley nut so pulley can take up belt slack. Tighten pulley nut to specification. Install injection pump pulley flange so flange hole aligns with camshaft pulley mark. Turn engine 2 revolutions. Ensure marks are still aligned when No. 1 cylinder is at TDC of compression stroke.
  5. Belt tension between injection pump pulley and crankshaft pulley should be 33-55 lbs. (15-25 kg) when measured with tension gauge. To complete installation, reverse removal procedure. Adjust injection timing.