LEMON Manuals: Even more car manuals for everyone

Entering Diagnostic Mode

  1. Turn ignition on. "CHECK ENGINE" light should glow. Locate diagnostic test lead (White wire) and ground lead (Black wire) taped to wire harness about 8" from ECM connector.
  2. Connect test lead to ground lead and note "CHECK ENGINE" light. "CHECK ENGINE" light will flash trouble code 12 once, pause a short time, then code 12 will repeat 2 more times. This indicates that self-diagnostic system is working.
  3. If any trouble codes are stored in ECM memory, the "CHECK ENGINE" light will flash 2-digit codes. Trouble codes will be displayed from lowest to highest numbered code (3 times each) and be repeated as long as the diagnostic terminals are connected. Remove ground lead from test lead before starting engine.
ECM TROUBLE CODE IDENTIFICATION

Code Problem
12 (1) No Ignition Reference Pulse to ECM
13 Oxygen Sensor Circuit
14 Shorted Coolant Sensor Circuit
15 Open Coolant Sensor Circuit
21 Idle Switch Circuit Open or WOT Switch Circuit Shorted
22 Fuel Cut Solenoid Circuit Open or Grounded
23 M/C Solenoid Circuit Open or Grounded
25 Air Switching Solenoid Circuit Open or Grounded
31 (2) No Ignition Reference Pulse to ECM at Part Throttle, Under Road Load
44 Lean Oxygen Sensor Indication
45 Rich System Indication
51 Shorted Fuel Cut Solenoid Circuit and/or Faulty ECM
52 Faulty ECM (RAM Problem in ECM)
53 Shorted Air Switching Solenoid and/or Faulty ECM
54 Shorted M/C Solenoid and/or Faulty ECM
55 Faulty ECM (A/D Converter in ECM)
(1) This code is not stored in memory and will only flash while fault is present.
(2) This code will be stored in memory.