LEMON Manuals: Even more car manuals for everyone

Confirmation Procedure

  1. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 

    Start the engine.

    Does the engine start?

    YES

    GO TO 3.

    NO

    Proceed to DTC Diagnosis Procedure .

  3. PERFORM DTC CONFIRMATION PROCEDURE-II 
    1. Warm up the engine to the normal operating temperature.
      NOTE: For best results, warm up the engine until "COOLAN TEMP/S" on "DATA MONITOR" mode of "ENGINE" reaches at least 70 deg.C (158 deg.F).
    2. Keep the engine speed at 3, 500 rpm for 5 seconds and let it idle at least 60 seconds.
    3. Check the 1st trip DTC.
      NOTE: If the fuel tank has sufficient fuel, this diagnosis result may not be detected.

    Is DTC P1197 detected?

    YES

    Proceed to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END