DTC Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn Ignition Switch OFF and wait at least 10 seconds.
- Turn Ignition Switch ON.
- Turn Ignition Switch OFF and wait at least 10 seconds.
GO TO STEP 2 .
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn Ignition Switch ON and wait at least 10 seconds.
- Press MAIN Switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press CANCEL Switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press RESUME/ACCELERATE Switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press SET/COAST Switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Check DTC.
Is DTC detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END