Diagnostic Test
- CHECK BATTERY CURRENT SENSOR
- Turn Ignition Switch OFF.
- Reconnect harness connectors disconnected.
- Disconnect battery negative cable (1).
: To body ground
- Install jumper cable (A) between battery negative terminal and body ground.
- Turn Ignition Switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
ECM Voltage (V) Connector + - Terminal Terminal F113 91
(Battery Current Sensor signal)95 Approx. 2.5 Before measuring the terminal voltage, confirm that the battery is fully charged. Refer to HOW TO HANDLE BATTERY .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace battery negative cable assembly.