LEMON Manuals: Even more car manuals for everyone

Diagnosis Procedure

  1. CHECK FDC OFF SWITCH CIRCUIT 
    1. Turn the ignition switch OFF.
    2. Disconnect ABS actuator and electric unit (control unit) harness connector.
    3. Disconnect triple switch harness connector.
    4. Check continuity between ABS actuator and electric unit (control unit) harness connector and triple switch harness connector.
      ABS actuator and electric unit (control unit) Triple switch Continuity
      Connector Terminal Connector Terminal
      E41 30 M183 3 Existed
    5. Check continuity between ABS actuator and electric unit (control unit) harness connector and ground.
      ABS actuator and electric unit (control unit) - Continuity
      Connector Terminal
      E41 30 Ground Not existed

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace error-detected parts.

  2. CHECK FDC OFF SWITCH GROUND CIRCUIT 

    Check continuity between triple switch harness connector and ground.

    Triple switch - Continuity
    Connector Terminal
    M183 5 Ground Existed

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Repair or replace error-detected parts.

  3. CHECK FDC OFF SWITCH 

    Check FDC OFF switch. Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 4.

    NO: Replace FDC OFF switch. Refer to "REMOVAL AND INSTALLATION ".

  4. CHECK FDC OFF SWITCH SIGNAL 

    With CONSULT

    1. Connect ABS actuator and electric unit (control unit) harness connector.
    2. Connect triple switch harness connector.
    3. Select "ABS", "DATA MONITOR" and "OFF SW" according to this order. Check FDC OFF switch signal.
      Condition DATA MONITOR
      When FDC OFF switch is pressed and FDC OFF indicator lamp in combination meter is in ON status On
      When FDC OFF switch is pressed and FDC OFF indicator lamp in combination meter is in OFF status Off

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 5.

  5. CHECK TERMINAL 
    • Check ABS actuator and electric unit (control unit) pin terminals for damage or loose connection with harness connector.
    • Check triple switch pin terminals for damage or loose connection with harness connector.

      Is the inspection result normal? 

      YES: Replace ABS actuator and electric unit (control unit). Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace error-detected parts.