Diagnosis Procedure
- PERFORM ECM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for "ENGINE".
Is any error system detected?
YES: Check the DTC. Refer to "DTC INDEX " (VQ37VHR for USA and Canada), or "DTC INDEX " (VK56VD for USA and Canada), .
NO: GO TO 2.
- CHECK ENGINE SPEED SIGNAL CIRCUIT
- Turn the ignition switch OFF.
- Disconnect ECM harness connectors.
- Disconnect power steering control unit harness connector.
- Check the continuity between ECM harness connector and power steering control unit harness connector.
Power steering control unit ECM Continuity Connector Terminal Connector Terminal M108 10 M107(1)
M160(2)110(1)
169(2)Existed (1) VQ37VHR (2) VK56VD Is the inspection result normal?
YES: GO TO 3.
NO: Repair or replace damaged parts.
- CHECK ENGINE SPEED SIGNAL (ECM)
- Connect ECM harness connectors.
- Check the signal between ECM harness connector and ground with oscilloscope.
ECM - Condition Value (Approx.) Connector Terminal M107(1)
M160(2)110(1)
169(2)Ground Engine speed: At idle (Warm-up condition) VQ37VHR VK56VD Engine speed: Approx. 2, 000 rpm (Warm-up condition) VQ37VHR VK56VD (1) VQ37VHR (2) VK56VD Is the inspection result normal?
YES: GO TO 4.
NO: Replace ECM. Refer to "DESCRIPTION " (VQ37VHR for USA and Canada), or "DESCRIPTION " (VK56VD for USA and Canada), .
- CHECK ENGINE SPEED SIGNAL (POWER STEERING CONTROL UNIT)
- Turn the ignition switch OFF.
- Connect power steering control unit harness connector.
- Check the signal between power steering control unit harness connector and ground with oscilloscope.
Power steering control unit - Condition Value (Approx.) Connector Terminal M108 10 Ground Engine speed: At idle (Warm-up condition) VQ37VHR VQK56VD Engine speed: Approx. 2, 000 rpm (Warm-up condition) VQ37VHR VK56VD Is the inspection result normal?
YES: GO TO 5.
NO: Replace power steering control unit. Refer to "REMOVAL AND INSTALLATION ".
- CHECK TERMINALS AND HARNESS CONNECTORS
- Check the power steering control unit pin terminals for damage or loose connection with harness connector.
- Check ECM pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES: INSPECTION END
NO: Repair or replace damaged parts.