LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to D (A/T) or 1st (M/T) position.
    6. Check the voltage between ECM harness connector terminals under the following conditions.
      TERMINAL VOLTAGE REFERENCE CHART

      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      F101 30 [TP sensor 1 (bank 1)] 40 Accelerator pedal Fully released More than 0.36
      Fully depressed Less than 4.75
      31 [TP sensor 1 (bank 2)] 48 Fully released More than 0.36
      Fully depressed Less than 4.75
      34 [TP sensor 2 (bank 1)] 40 Fully released Less than 4.75
      Fully depressed More than 0.36
      35 [TP sensor 2 (bank 2)] 48 Fully released Less than 4.75
      Fully depressed More than 0.36

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace malfunctioning electric throttle control actuator.
    2. Go to "SPECIAL REPAIR REQUIREMENT ".

      INSPECTION END