LEMON Manuals: Even more car manuals for everyone

Disassembly and Assembly: Seatback: Disassembly

  1. Remove seatback trim and seatback pad.
    NOTE: Seatback trim and seatback pad can be removed without removing seatback assembly from seat body.
    • Remove the retainer from the lower side of seatback board.
    • Disconnect the clips and pawls, and then remove the seatback board.

      : Pawl

      ◦ : Clip

      Fig 1: Identifying Clips And Pawls
      G05213115Courtesy of NISSAN MOTOR CO., U.S.A.
    • Remove the seatback hinge mounting bolts.
    • Remove the retainer on the back side of the seatback.
      Fig 2: Identifying Seatback Hinge Mounting Bolts
      G05213116Courtesy of NISSAN MOTOR CO., U.S.A.
    • Remove the seat speaker grills. (Applied 5.1 ch BOSE studio surround® system models.) Refer to SEAT SPEAKER .
    • Remove the headrest holder.
      CAUTION: Before installing headrest holder, check its orientation (front/rear and right/left).
      Fig 3: Identifying Headrest Holder
      G04928096Courtesy of NISSAN MOTOR CO., U.S.A.
    • Disconnect the clip, and then remove the reclining device cover.
    • Remove the screws, and then remove the seatback upper finisher.
      Fig 4: Identifying Seatback Upper Finisher
      G05213118Courtesy of NISSAN MOTOR CO., U.S.A.
    • Remove the bracket mounting nuts.
    • Remove seatback trim and pad from seatback frame.
    • Remove the hog rings to separate the trim and pad.
  2. Remove seatback frame.
    • Remove seat speaker. (Applied 5.1 ch BOSE studio surround® system models) Refer to SEAT SPEAKER .
    • Remove the bands, and then remove seatback thermal electrical device (TED) assembly.
    • Remove the seat harness assembly from seatback assembly.
    • Remove the bolts, and then remove seatback frame from seat cushion frame.