LEMON Manuals: Even more car manuals for everyone

Check Automatic Drive Positioner Control Unit Power Supply and Ground Circuit

  1. CHECK POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit connector.
    3. Check voltage between automatic drive positioner control unit connector and ground.
      VOLTAGE SPECIFICATION

      Terminals Voltage (V) (Approx.)
      (+) (-)
      Automatic drive positioner control unit connector Terminal
      M7 34 Ground Battery voltage
      39
      Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground
      G05212900Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 2.

    NG: Repair or replace harness between automatic drive positioner control unit and fuse block (J/B).

  2. CHECK GROUND CIRCUIT 

    Check continuity between the automatic drive positioner control unit connector and ground.

    CONTINUITY SPECIFICATION

    Automatic drive positioner control unit connector Terminal Ground Continuity
    M7 40 Yes
    48

    OK or NG 

    OK: Automatic drive positioner control unit power supply and ground circuit are OK.

    NG: Repair or replace harness between automatic drive positioner control unit and ground.

    Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit Connector And Ground
    G05212901Courtesy of NISSAN MOTOR CO., U.S.A.