LEMON Manuals: Even more car manuals for everyone

Disassembly and Assembly: Assembly

  1. Install the inner sockets.
  2. Install the large-diameter side of the boots to the gear housing assembly.
  3. Install the small-diameter side of the boots to the groove of the inner sockets.
    Fig 1: Identifying Boot Clamp To Large And Small-Diameter Side Of Boot
    G04876909
  4. Install the boot clamps to the boots, as shown.
    CAUTION: Do not reuse the large-diameter boot clamps.
    Fig 2: Identifying Large And Small Boot Clams
    G04902323
  5. Crimp the large-diameter boot clamps, using Tool.

    Tool number : KV40107300 ( - ) 

  6. Install the cylinder tubes to the gear housing assembly.
  7. Install the lock nuts and outer sockets to the inner sockets.
    Fig 3: Tightening Boot Band
    G04902012
  8. Thread the outer sockets onto the inner sockets to the specified length "L", then tighten the lock nuts to the specification. Refer to "REMOVAL AND INSTALLATION ". Reconfirm that the tie-rod length "L" is within specification.

    Maximum inner socket length "L" : 115.2 mm (4.54 in) 

    Fig 4: Identifying Inner Socket, Lock Nut And Outer Socket
    G04876915