LEMON Manuals: Even more car manuals for everyone

Removal and Installation: Installation

Reverse the removal procedure for installation attentive to the following operation.

NOTE:
  • The neutral position is set as follows.

    Turn quietly the spiral cable clockwise to the end position. Then turn it counterclockwise (about 2 and half turns) and stop turning at the point on which the stopper insertion holes are in the same position (showed as B in the figure). The service part is installed in the neutral position by the stopper and can be set without adjusting after the stopper is removed.

CAUTION: Do not run spiral cable idle needlessly. And do not turn it more than necessary (or it leads to disconnection of the cable).