Removal and Installation: Installation
- Installation is the reverse order of removal. For tightening torque, refer to , "COMPONENTS ".
- When installing lower joint to steering gear assembly, follow the procedure listed below.
- Set rack of steering gear in the neutral position.NOTE: To get the neutral position of rack, turn gear-sub assembly and measure the distance of inner socket, and then measure the intermediate position of the distance.
- Align rear cover cap projection (A) with the marking position (B) of gear housing assembly.
- Install slit part of lower joint (C) aligning with the projection (A) of rear cover cap (1). Make sure that the slit part of lower joint (C) is aligned with both the projection (A) of rear cover cap (1) and the marking position (B) of gear housing assembly.
- Set rack of steering gear in the neutral position.
- After installation, bleed air from the steering hydraulic system. Refer to , "AIR BLEEDING HYDRAULIC SYSTEM ".
- Perform final tightening of nuts and bolts on each part under unladen conditions with tires on level ground when removing steering gear assembly. Check wheel alignment. Refer to "WHEEL ALIGNMENT INSPECTION ", "WHEEL ALIGNMENT INSPECTION ".
- Adjust neutral position of steering angle sensor after checking wheel alignment. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ".