LEMON Manuals: Even more car manuals for everyone

Rear Lifting Motor Circuit Check

  1. CHECK REAR SEAT LIFTING MECHANISM 

    Check the following.

    • Operation malfunction caused by lifter mechanism deformation or pinched harness or other foreign materials
    • Operation malfunction caused by foreign materials adhered to the rear lifting motor or lead screws
    • Operation malfunction and interference with other parts by poor installation

    OK or NG 

    OK: GO TO 2.

    NG: Repair or replace the malfunctioning part and check again.

  2. CHECK FUNCTION 

    With CONSULT-II 

    Check operation with "SEAT LIFTER RR" in ACTIVE TEST.

    TEST ITEM DESCRIPTION

    Test item Description
    SEAT LIFTER
    RR
    The rear lifting motor is activated by receiving the drive signal.
    Fig 1: CONSULT II ACTIVE TEST Screen
    G04145940Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Rear lifting motor circuit is OK.

    NG: GO TO 3.

  3. CHECK REAR LIFTING MOTOR CIRCUIT HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect driver seat control unit and rear lifting motor connector.
    3. Check continuity between driver seat control unit connector and rear lifting motor connector.
      DRIVER SEAT CONTROL UNIT CONNECTOR AND REAR LIFTING MOTOR CONNECTOR CONTINUITY

      A B Continuity
      Driver seat control unit connector Terminal Rear lifting motor connector Terminal
      B205 38 B210 38 Yes
      39 39
    4. Check continuity between driver seat control unit connector and ground.
    DRIVER SEAT CONTROL UNIT CONNECTOR AND GROUND CONTINUITY

    A Ground Continuity
    Driver seat control unit connector Terminal
    B205 38 No
    39
    Fig 2: Identifying Continuity Between Driver Seat Control Unit Connector And Rear Lifting Motor Connector
    G04145941Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace harness.

  4. CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL 
    1. Connect the driver seat control unit connector.
    2. Check voltage between driver seat control unit connector and ground.
DRIVER SEAT CONTROL UNIT CONNECTOR AND GROUND VOLTAGE

Driver seat control unit connector Terminals Condition Voltage (V) (Approx.)
(+) (-)
B205 38 Ground Lifting switch (rear) ON (UP operation) Battery voltage
Other than above 0
39 Lifting switch (rear) ON (DOWN operation) Battery voltage
Other than above 0
Fig 3: Identifying Voltage Between Driver Seat Control Unit Connector And Ground
G04145942Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace rear lifting motor.

NG: Replace driver seat control unit.