LEMON Manuals: Even more car manuals for everyone

Consult-II Setting Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower driver panel.
    Fig 1: Connecting CONSULT-II And CONSULT-II Converter To Data Link Connector
    G02362601Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Touch "START (NISSAN BASED VHCL)".
    Fig 2: Identifying Display - Consult II
    G02362602Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "A/T".

    If "A/T" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    Fig 3: Identifying Display - Select System
    G02362603Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Perform each diagnostic test mode according to each service procedure.
    Fig 4: Identifying Display - Select Diag Mode
    G02362604Courtesy of NISSAN MOTOR CO., U.S.A.