LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. SHIFT ACTUATOR POSITION SWITCH 

    Refer to ACTUATOR AND ACTUATOR POSITION SWITCH .

    OK or NG

    1. OK: GO TO 3.
    2. NG: GO TO 2.
  2. CHECK POSITION SWITCH 

    Recheck continuity of shift actuator position switch.

    Refer to ACTUATOR AND ACTUATOR POSITION SWITCH .

    Continuity should exist. 

    OK or NG

    1. OK: GO TO 3.
    2. NG: Repair or replace position switch.
  3. CHECK INPUT SIGNAL 

    Do you have CONSULT-II?

    Yes or No

    1. Yes: GO TO 4.
    2. No: GO TO 5.
  4. CHECK INPUT SIGNAL 

    With CONSULT-II 

    1. Start engine (idling).
    2. Select "SELF-DIAG RESULTS" in Select Diag Mode.
    3. Fig 1: Identifying Transfer Control Unit Wiring Diagram
      G02250539Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Read out self-diagnostic result.
      Fig 2: Displaying CONSULT-II SELF-DIAG RESULTS Screen
      G02250540Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: GO TO 6.
    2. NG: Check the following.
      • Continuity between transfer control unit and transfer control device.
      • Check ground circuit between transfer control device and ground.
  5. CHECK INPUT SIGNAL 

    Without CONSULT-II 

    1. Start engine (idling).
    2. Check voltage transfer control unit harness connector E143 terminal 27 (W/L) [or 44 (LG/B)] and ground while 4WD shift switch is set from 4H to 4LO (or from 4LO to 4H).
    3. Fig 3: Checking Voltage Between Terminal 27 Or 44 And Ground
      G02250541Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Result
      Fig 4: Terminal Condition Table
      G02250542Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: GO TO 6.
    2. NG: Check the following.
      • Continuity between transfer control unit and transfer control device.
      • Check ground circuit between transfer control device and ground.
  6. PERFORM SELF-DIAGNOSIS AGAIN 

    After driving for a while, perform self-diagnosis again.

    Refer to TROUBLE DIAGNOSIS WITHOUT CONSULT-II .

    OK or NG

    1. OK: Inspection End.
    2. NG:
      1. Perform transfer control unit/output signal inspection. Refer to TRANSFER CONTROL UNIT INSPECTION TABLE .
      2. If NG, recheck transfer control unit pin terminals for damage or loose connection with harness connector.