LEMON Manuals: Even more car manuals for everyone

Clutch Piston

  1. Apply ATF or petroleum jelly to new D-rings, and install them to clutch piston.
    NOTE: Do not reuse D-rings.
  2. Fig 1: Installing D-Rings To Clutch Piston
    G02248809Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install thrust needle bearing race to clutch piston.
  4. Fig 2: Installing Thrust Needle Bearing Race To Clutch Piston
    G02248810Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Install clutch piston to the center case as shown.
    CAUTION: Install so the fitting protrusion of the clutch piston with aligns the dent of the center case.
  6. Fig 3: Installing Clutch Piston To Center Case
    G02248811Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove all the liquid gasket from oil pressure check port and inside center case. With the new oil pressure check plug threaded in 1 or 2 pitches, apply specified sealant or equivalent, to the oil pressure check plug thread of plug, and tighten. Refer to RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS .

    Oil pressure check plug :15 N.m (1.5 kg-m, 11 in-lb) 

    NOTE: Do not reuse oil pressure check plug.
  8. Install mainshaft and clutch drum. Refer to MAINSHAFT AND CLUTCH DRUM .
Fig 4: Installing Oil Pressure Check Plug
G02248812Courtesy of NISSAN MOTOR CO., U.S.A.