LEMON Manuals: Even more car manuals for everyone

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II 

  1. Start engine.
  2. Accelerate vehicle to maintain the following conditions.

    ACCELE POSI: 1.5/8 - 2.0/8 

    Selector lever: "D" position 

    Gear position: 3rd ==> 4th Gear (I/C ON/OFF) 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

  3. Perform step "2" again.
  4. Turn ignition switch "OFF", then perform step "1" to "3" again.
  5. Check "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II. If DTC (P1754) is detected, Refer to DIAGNOSTIC PROCEDURE .

    If DTC (P1752) is detected, go to DIAGNOSTIC PROCEDURE .

    If DTC (P1843) is detected, go to DIAGNOSTIC PROCEDURE .

Fig 1: Displaying CONSULT-II SELECT SYSTEM Screen
G02250015Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

Follow the procedure "With CONSULT-II".